Windows tooling

Before plugging the Serial module, run the following command on the terminal:

$ mode

It will print a list of devices that are connected to your laptop. The ones that start with COM in their names are serial devices. This is the kind of device we'll be working with. Take note of all the COM devices mode outputs before plugging the serial module.

Now, plug the Serial module and run the mode command again. You should see a new COM command appear on the list. That's the COM port assigned to the serial module.

Now launch putty. A GUI will pop out.

On the default screen, "Session", pick "Serial" as the "Connection type". On the "Serial line" field enter the COM device you got on the previous step, for example COM3.

Next, pick the "Connection/Serial" menu item from the menu on the left. On this new view, make sure that the serial port is configured as follows:

  • "Speed (baud)": 115200
  • "Data bits": 8
  • "Stop bits": 1
  • "Parity": None
  • "Flow control": None

Finally, click the Open button. A console will show up now:

If you type on this console, the TX (red) LED on the Serial module should blink. Each key stroke should make the LED blink once. Note that the console won't echo back what you type so the screen will remain blank.